Talker™
The Talker™ is an effect designed exclusively by DigiTech, which enables your instrument to speak.The
Talker™ requires a microphone to be connected to the Mic Input on the rear panel of the RP2000.As
you speak into the microphone, your instrument will mimic any words that you say.The Talker™ effect
is produced only at the 1/4” left and right outputs.When the Talker™ is bypassed, the mic signal is
passed from the XLR mic in to the XLR mic out unaffected.There are four types of Talker™ selections
to choose from.
This Parameter is used to turn the Talker™ on and off.
This Parameter is used to select the 4 Talker™ types. Ranges from type 1 (deep tonal
characteristics), to type 4 (bright tonal characteristics).
This Parameter is used to adjust the microphone sensitivity for the Talker™ effect.The Talker™ must
have an appropriate input level from your microphone in order to work properly. If the microphone
input is too weak, the Talker™ will have trouble tracking. If the input is too strong, the Talker™ will clip
making the words unintelligible.The Mic Sensitivity ranges from 1 being the least sensitive to 99 being
the most sensitive.
Noise Gate
A Noise Gate is designed to eliminate noise while you are not playing. It looks at the strength of the
incoming signal and if the signal exceeds the value set by the Threshold Parameter, the Gate will open
and allow the signal to pass. If your signal level drops below the Threshold, the Gate will close and allow
nothing through until the Threshold is exceeded again.The Type parameter allows you to select between
a normal Noise Gate, or an automatic volume swell effect taking up to 2 seconds for the volume to fade
in.The Noise Gate is accessed by using the Talker™ button in the Matrix.
This Parameter turns the Noise Gate on and off.
This Parameter is used to select between the Noise Gate settings or the Automatic swell settings.Your
choices include: nredct (a normal type of Noise Gate noise reduction), to Swell 1 (being a quick
volume swell) through Swell 10 (being a slow volume swell).
Sets the signal strength level required for the Noise Gate to open or close. Ranges from 1 (weakest) to
99 (strongest).
Effects
The Effects column in the RP2000 is a multi-function module, allowing you to select effects such as;
Chorus, Flanger, Phaser,Tremolo, Panner,Vibrato, Rotary Speaker, AutoYah™,YahYah™, Envelope,
Detune, and Pitch Shift effects. Only one of these effects can be used at a time.After selecting the type
of effect in this module, you can then adjust the effects individual parameters.
This Parameter turns the Effects module on and off.
This Parameter allows you to select the specific type of effect from this group.The following list
describes each of these Effects and their associated Parameters in detail:
Page 17
Section Three - Effects and Parameters
RP2000 User’s Guide
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern