DigiTech RP2000 Betriebsanweisung PDF herunterladen (Seite 9)

Getting Started

Making Connections

Before connecting the RP2000, make sure that the power to your amplifier is turned off, and that the power to the

RP2000 is disconnected.There is no power switch on the RP2000.To turn the RP2000 on or off, simply connect or

disconnect the power supply from an AC outlet.

There are several different connection options available when using the RP2000.You may run mono into an amp or

power amp, stereo into two amps or a stereo power amp, direct into a mixing console, connect digitally to the input of

a digital recorder or mixer, or a combination of these.The following diagrams show the connections for some of these

options.

NOTE: The RP2000 is a preamp. Running The RP2000 signal into the input of a combo guitar amplifier will preamplify

the signal again possibly adding noise and feedback.When using a guitar amp, it may be best to connect the guitar to

the input of the RP2000 and the output of the RP2000 to the effect return of the amplifier.

Mono Operation

Connect your guitar to the input of the RP2000. Connect the Left output of the RP2000 to the instrument input on

your amplifier, or to the line input of a power amp. Select Mono as the Output mode in the Utility menu. See page 30

for more on selecting the Output mode.

Stereo Operation

For stereo operation connect the guitar to the input of the RP2000. Connect from the RP2000’s Left output to the

input of one amplifier or channel of a power amp. Connect from the Right output of the RP2000 to a second amplifier,

or to a second channel of a power amp. Select Stereo as the Output mode in the Utility menu. See page 30 for more

on selecting the Output mode.

Input

Left Output

Page 5

Section One - Introduction

RP2000 User’s Guide

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 41 42

Keine Kommentare

DigiTech RP2000 Betriebsanweisung Seite 9