Chorus (Chorus)
A Chorus adds a short delay to your signal and modulates the delay time which takes the delayed signal
slightly in and out of tune.The delayed signal is then mixed back with the original signal to create a thicker
sound as if two guitars were playing the same part. Chorus Parameters are as follows:
Speed - Controls the rate that the Chorus modulates at. Ranges from 0 to 99.
Depth - Sets the amount of intensity in the Chorus. Ranges from 0 to 99.
chodly- Adjusts the Delay time used in the Chorus. Ranges from 0 to 40 milliseconds.
Flange (Flanger)
A Flanger uses the same principle as a Chorus does with a modulating delay.The difference being that a
Flanger uses a shorter delay time and adds regeneration (or repeats) to the modulating delay.This results in
an exaggerated up and down sweeping motion to the effect. Flange Parameters are as follows:
Speed - Controls the rate that the Flange modulates at. Ranges from 0 to 99.
Depth - Sets the intensity in the Flange effect. Ranges from 1 to 15.
Regen - This Parameter sets the amount of regeneration which is perceived as the up and
down motion of the Regeneration ranges from 0 to 99.
Phaser (Phaser)
A phaser splits the incoming signal, and then changes the phasing of the signal.This signal is then taken in
and out of phase and mixed back in with the original signal. As the phasing changes, different frequencies
get canceled resulting in a warm sort of twisting sound.The RP2000 breathes new life into this classic effect
by adding regeneration.
Speed - Controls the rate of the Phaser sweep. Ranges from 0 to 99.
Depth - Sets the intensity or amount of Phase change in the split signal. Ranges from 0 to
99.
Regen - Controls the amount of phased sound fed back to the input of the Module. High
regeneration settings produce dramatic and interesting unnatural sounds. Ranges
from 0 to 99.
Trmolo (Tremolo)
A Tremolo effect modulates the volume of the incoming signal at a steady, even rate.The incoming signal
will go back and forth between getting louder and softer. It is kind of like having a motor on your guitars
volume knob which opens and closes the volume at an even rate.
Speed - Controls the rate of volume modulation. Ranges from 0 to 99.
Depth - Adjusts the intensity of the Tremolo effect. Ranges from 0 to 99.
Page 18
Section Three - Effects and Parameters
RP2000 User’s Guide
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern